Mass flow sensor using dual SAW device

Tooru Nomura, Atushi Saitoh, Koichi Koyama

研究成果: Conference contribution

2 被引用数 (Scopus)

抄録

The application of SAW devices to a thermometric mass flow rate meter with a reference channel for temperature compensation is presented. The sensor is composed of a delay line device with two channels, namely a reference channel that does not come in contact with the fluid and a sensing channel that makes contact with the fluid. The mass flow rate of gases can be obtained by measuring the temperature change of the device caused by drawing heat from the surface with constant temperature due to the fluid. The results obtained from flow rate measurements of several gases demonstrate that the proposed device is effective as a flow rate meter. Moreover, it is also shown that the response characteristics to mass flow rate changes and the response stability for fluids were improved by taking the phase difference between the signals of the reference channel and the sensing channel as the gas flow rate.

本文言語English
ホスト出版物のタイトル2007 IEEE International Frequency Control Symposium Joint with the 21st European Frequency and Time Forum, FCS
ページ25-30
ページ数6
DOI
出版ステータスPublished - 2007 12月 1
イベント2007 IEEE International Frequency Control Symposium Joint with the 21st European Frequency and Time Forum, FCS - Geneva, Switzerland
継続期間: 2007 5月 292007 6月 1

出版物シリーズ

名前Proceedings of the IEEE International Frequency Control Symposium and Exposition

Conference

Conference2007 IEEE International Frequency Control Symposium Joint with the 21st European Frequency and Time Forum, FCS
国/地域Switzerland
CityGeneva
Period07/5/2907/6/1

ASJC Scopus subject areas

  • 工学(全般)

フィンガープリント

「Mass flow sensor using dual SAW device」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル